User's Manual

U SER A UTHENTICATION
3-75
CLI – Specify all the required parameters to enable logon authentication.
Configuring HTTPS
You can configure the switch to enable the Secure Hypertext Transfer
Protocol (HTTPS) over the Secure Socket Layer (SSL), providing secure
access (i.e., an encrypted connection) to the switch’s web interface.
Command Usage
• Both the HTTP and HTTPS service can be enabled independently on the
switch. However, you cannot configure both services to use the same
UDP port.
Console(config)#authentication login radius 4-98
Console(config)#radius-server port 181 4-102
Console(config)#radius-server key green 4-102
Console(config)#radius-server retransmit 5 4-103
Console(config)#radius-server timeout 10 4-103
Console(config)#radius-server 1 host 192.168.1.25 4-101
Console(config)#exit
Console#show radius-server 4-104
Remote RADIUS server configuration:
Global settings:
Communication key with RADIUS server: *****
Server port number: 181
Retransmit times: 5
Request timeout: 10
Server 1:
Server IP address: 192.168.1.25
Communication key with RADIUS server: *****
Server port number: 181
Retransmit times: 5
Request timeout: 10
Console#config
Console(config)#authentication login tacacs 4-98
Console(config)#tacacs-server host 10.20.30.40 4-105
Console(config)#tacacs-server port 200 4-106
Console(config)#tacacs-server key green 4-106
Console(config)#exit
Console#show tacacs-server 4-107
Server IP address: 10.20.30.40
Communication key with tacacs server: green
Server port number: 200
Console(config)#