User's Manual

C OMMAND L INE I NTERFACE
4-11
Command Groups
The system commands can be broken down into the functional groups
shown below
.
Table 4-4 Command Group Index
Command Group Description Page
Line Sets communication parameters for the serial port and
Telnet, including baud rate and console time-out
4-14
General Basic commands for entering privileged access mode,
restarting the system, or quitting the CLI
4-25
System
Management
Controls system logs, system passwords, user name,
browser management options, and a variety of other
system information
4-31
Flash/File Manages code image or switch configuration files 4-81
Authentication Configures logon access using local or remote
authentication; also configures port security and IEEE
802.1X port access control
4-97
Access Control
Lists
Provides filtering for IP frames (based on address,
protocol, TCP/UDP port number or TCP control code)
or non-IP frames (based on MAC address or Ethernet
type)
4-119
SNMP Activates authentication failure traps; configures
community access strings, and trap managers; also
configures IP address filtering
4-151
Interface Configures the connection parameters for all Ethernet
ports, aggregated links, and VLANs
4-170
Mirror Port Mirrors data to another port for analysis without
affecting the data passing through or the performance of
the monitored port
4-184
Rate Limiting Controls the maximum rate for traffic transmitted or
received on a port
4-186
Link Aggregation Statically groups multiple ports into a single logical
trunk; configures Link Aggregation Control Protocol
for port trunks
4-188