User's Manual

G ENERAL C OMMANDS
4-26
Command Usage
• “super” is the default password required to change the command mode
from Normal Exec to Privileged Exec. (To set this password, see the
enable password command on page 4-36.)
• The “#” character is appended to the end of the prompt to indicate that
the system is in privileged access mode.
Example
Related Commands
disable (4-26)
enable password (4-36)
disable
This command returns to Normal Exec mode from privileged mode. In
normal access mode, you can only display basic information on the switch's
configuration or Ethernet statistics. To gain access to all commands, you
must use the privileged mode. See “Understanding Command Modes” on
page 4-6.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
The “>” character is appended to the end of the prompt to indicate that
the system is in normal access mode.
Example
Related Commands
enable (4-25)
Console> enable
Password: [privileged level password]
Console#
Console#disable
Console>