User's Manual

C ONFIGURING THE S WITCH
3-30
This example shows how to download a PoE controller file from a TFTP
server.
This example shows how to copy a PoE controller file from another unit
in the stack.
Console Port Settings
You can access the onboard configuration program by attaching a VT100
compatible device to the switch’s serial console port. Management access
through the console port is controlled by various parameters, including a
password, timeouts, and basic communication settings. These parameters
can be configured via the Web or CLI interface.
Command Attributes
• Login Timeout – Sets the interval that the system waits for a user to log
into the CLI. If a login attempt is not detected within the timeout interval,
the connection is terminated for the session. (Range: 0 - 300 seconds;
Default: 0)
• Exec Timeout – Sets the interval that the system waits until user input
is detected. If user input is not detected within the timeout interval, the
current session is terminated. (Range: 0 - 65535 seconds; Default: 600
seconds)
Console#copy tftp file 4-82
TFTP server IP address: 10.3.4.50
Choose file type:
1. config: 2. opcode 3. PD_Controller: <1-3>: 3
Source file name: 7012_007.s19
Destination file name: PoE-test
Write to FLASH Programming.
Write to FLASH finish.
Success.
Console#
Console#copy file controller 4-82
Unit <1-2>: 2
Choose controller type:
1. PoE: 2. VDSL: 3. TBD <1-3>: 1
Source file name: PoE-test
Software downloading in progress, please wait...
Unit 1 done
Console#