User's Manual

DRAFT Page 2 | August 10, 2010
Table 1: Troubleshooting the Camera Installation
Action Button
Icon
LED Display Description
Flashes red once and then
lights red for three
seconds
Used when everyone is leaving the
house.
Arm System in Arm Stay Mode
 Alarm trips immediately if a monitored Perimeter zone (non-entry/exit
door or window) is opened.
 Interior motion detectors are armed.
 Entry/Exit zones start an Entry Delay
 Exit Delay starts when the system is armed
Entry/Exit Delay
 When armed, the system audibly beeps slowly over and over announcing
that the system is in the Exit Delay period. During the last 10 seconds
of the Exit Delay state, the system audibly fast beeps (two beeps per
second).
 A numerical countdown timer on the SMA Gateway indicates how much
time remains in the Exit Delay.
 If an entry/exit zone is faulted, restored and then faulted again prior to
the end of the exit delay then the Exit Delay is restarted. This only occurs
once.
 If no Entry/Exit Zone opens and closes during the Exit Delay, the
Arming Mode reverts to Armed Stay.
 After Exit Delay, the Security Status header is relabeled Armed Away and
sounds 2 short beeps.
 If an Entry/Exit zone is opened the Entry Delay period starts with an
audible beep each second. The system beeps twice per second in the last
10 seconds of the Entry Delay period. The keypad code must be entered
during this period to avoid sounding an alarm. During the Entry Delay
period, the motion detectors will not log events.