User's Manual

DRAFT Page 3 | August 10, 2010
Table 1: Troubleshooting the Camera Installation
Action Button
Icon
LED Display Description
Flashes red once and then
lights red for three
seconds
Used to arm the system when there
are still people in the premises.
Arm System in Arm Away Mode
 Alarm trips immediately if a monitored Perimeter zone (non-entry/exit
door or window) is opened.
 Interior motion detectors not armed.
 Entry/Exit zones start an Entry Delay
 Exit Delay starts when the system is armed.
 Exit Delay does not beep and is twice the length of Alarm Away mode
Entry/Exit Delays
 When the system is armed, the Exit Delay period starts, BUT there is no
audible beep during the Exit Delay period (as there is in Arm Away). The
Exit Delay period is the time between the system being armed and the
alarms actually being activated. This gives the user time to leave through
an entry/exit security zone.
 The Exit Delay period is twice as long as for the Arm Away mode, and
there is no audible alert during the countdown.
 A numerical countdown timer indicates how much time remains in the
Exit Delay period.
 If an entry/exit zone is faulted, restored and then faulted again prior to
the end of the exit delay then the Exit Delay is restarted. This only occurs
once.
 After Exit Delay, the Security Status header is relabeled Armed Stay and
sounds 3 short beeps.
 When an entry/exit zone is opened the Entry Delay period sounds an
audible beep each second. The system beeps twice per second in the last
10 seconds of the Entry Delay period. The keypad code must be entered
during this period to avoid sounding an alarm.
Disarm System
Flashes green once and
then lights green for three
seconds
Disarms the system without an Entry
Delay
Panic Alarm
Flashes red once and then
flashes red six times
Immediately reports a Panic alarm to
the central monitoring station