User manual

Setup

[DHCP server present?]

Select [Yes] if you have a DHCP server on your network that will allow

the SMCWMR-AG to obtain an IP address

automatically. If you do

not have a DHCP server on your network, select

[No] and input your

IP, Subnet Mask, and Gateway addresses

g) [Is proxy present?]

Select [No] and press [OK] on your Remote Control to continue.

(Note: The majority of home networks use a standard Broadband

Router to share internet access. In this configuration, there is no

proxy present.) Some corporate networks may have proxies in place

for advanced security. To configure this setting, simply obtain the

proxy IP address and port from your Network Administrator and then

input this data via your Remote Control.

You have now completed the initial configuration. You will be asked to

confirm the changes by pressing [OK] to continue. The SMCWMR-AG

will reset and automatically connect to your network upon boot-up.

i) Once the SMCWMR-AG is connected, it will ask you to [Register

Now]. This will give you the option to upgrade your firmware via

Smart Box Management to take advantage of new updates.

(Note: You can register at any point by going to the [Settings] menu).