Datasheet

Connect Your World ...
Switches | Wireless | Broadband | Carrier Ethernet | Network Management
www.smc.com
www.smc-asia.com
WAP5110-E
802.11a/b/g/n Indoor Dual Band Wireless Access Point
Product Overview
The SMCWAP5110-E is an indoor 802.11a/b/g/n dual-band, dual-radio enterprise AP with a 2x2 MIMO antenna configuration.
Through its Gigabit Ethernet port supports wire speed (non-block), the 802.11n dual-band wireless AP can connect to the
backbone network. The SMCWAP5110-E supports 802.3af PoE, which enables the AP to be powered remotely by a PoE
switch. An AC power adapter option is also included for locations where PoE is not available.
Key Features and Benefits
Wireless 802.11n Technology
A new 802.11n (MIMO Multi Input Multi Output) Wireless
technology, It support 2 x RF transmitting and 2x RF receiving
to extend and increase 3~9 times bandwidth and throughput
than existing Wi-Fi accessing. It also operates the Spatial
Multiplexing to combine the RF signal.
Dual Band Access Point
Easy on your budget, simple to install and use dynamic rate
shifting automatically matches the best connection speed,
and WLAN Network connection keeps users connected to the
network, even while roaming.
Advanced Traffic Management
Supports up to sixteen Virtual Access Point (VAP) interfaces
per radio, which allow traffic to be separated for different
user groups within the same AP service area. Each radio can
support up to 100 wireless clients, shared with all VAP,
whereby the clients associate with each VAP in the same way
as they would with physically separate access points. This
means that each VAP can be configured with its own Service
Set Identification (SSID), security settings, VLAN assignments,
and other parameters, allowing the AP to serve a diverse
range of client needs in an area from a single unit.
Full Management Capabilities
WAP5110-E supports Simple Network Management Protocol
(SNMP v1/v2/v2c/v3) MIB II and I support. Power over
Ethernet is supported with stuffing option PoE circuit. IEEE
802.1x authentication protocol supports Extensible
Authentication Protocol (EAP) MD5, Transport Layer Security
(TLS), Protected EAP (PEAP), Tunneled TLS (TTLS), EAP-SIM
and EAP-AKA.
Application Diagram