User's Manual

Chapter 9 | Using the Command Line Interface
Entering Commands
– 114 –
AP#configure
AP(config)#
To enter Interface mode, you must enter the “interface ethernet” while in Global
Configuration mode. The system prompt will change to “AP(if-ethernet)#,” or
“AP(if-wireless 0)” indicating that you have access privileges to the associated
commands. You can use the exit command to return to the Exec mode.
AP(config)#interface ethernet
AP(if-ethernet)#
Command Line
Processing
Commands are not case sensitive. You can abbreviate commands and parameters
as long as they contain enough letters to differentiate them from any other
currently available commands or parameters. You can use the Tab key to complete
partial commands, or enter a partial command followed by the “?” character to
display a list of possible matches.