User's Manual

– 115 –
10 General Commands
This chapter details general commands that apply to the CLI.
configure This command activates Global Configuration mode. You must enter this mode to
modify most of the settings on the access point. You must also enter Global
Configuration mode prior to enabling the context modes for Interface
Configuration. See “Using the Command Line Interface” on page 109.
Default Setting
None
Command Mode
Exec
Example
AP#configure
AP(config)#
Related Commands
end
Table 4: General Commands
Command Function Mode Page
configure Activates global configuration mode Exec
115
end Returns to previous configuration mode GC, IC
116
exit Returns to the previous configuration mode, or exits the
CLI
any
116
cli-session-timeout Sets a timeout for CLI and Telnet sessions Exec
116
ping Sends ICMP echo request packets to another node on the
network
Exec
117
reset Restarts the system Exec
118
show line Shows the configuration settings for the console port Exec
118