User's Manual
Chapter 10
| General Commands
– 117 –
Command Mode
Exec
Example
The following example disables the CLI timeout.
AP(config)# cli-session-timeout disable
AP(config)#
ping This command sends ICMP echo request packets to another node on the network.
Syntax
ping <host_name | ip_address>
host_name - Alias of the host.
ip_address - IP address of the host.
Default Setting
None
Command Mode
Exec
Command Usage
◆ Use the ping command to see if another site on the network can be reached.
◆ The following are some results of the ping command:
■
Normal response - The normal response occurs in one to ten seconds,
depending on network traffic.
■
Destination does not respond - If the host does not respond, a “timeout”
appears in ten seconds.
■
Destination unreachable - The gateway for this destination indicates that
the destination is unreachable.
■
Network or host unreachable - The gateway found no corresponding entry
in the route table.
Example
AP#ping 192.168.1.19
192.168.1.19 is alive
AP#