User's Manual

– 119 –
11 System Management
Commands
These commands are used to configure the password, system logs, browser
management options, clock settings, and a variety of other system information.
Table 5: System Management Commands
Command Function Mode Page
country Sets the access point country code Exec
120
prompt Customizes the command line prompt GC
121
system name Specifies the host name for the access point GC
122
system-resource Sets rising and falling CPU and memory thresholds GC
122
password Specifies the password for management access GC
123
reboot-schedule Restarts the AP after a specified time GC
124
apmgmtui ssh enable Enables the Secure Shell server GC
124
apmgmtui ssh port Sets the Secure Shell port GC
125
ip telnet-server enable Enables the Telnet server GC
125
apmgmtip Specifies an IP address or range of addresses allowed
access to management interfaces
GC
129
apmgmtui telnet-
server
Enables Telnet management access GC
125
apmgmtui snmp Enables SNMP management access GC
129
apmgmtui http port Specifies the port to be used by the web browser
interface
GC
126
apmgmtui http server Allows the access point to be monitored or configured
from a browser
GC
126
apmgmtui http
session-timeout
Sets the web interface timeout GC
127
apmgmtui https port Specifies the UDP port number used for a secure HTTP
connection to the access point’s Web interface
GC
127
apmgmtui https
server
Enables the secure HTTP server on the access point GC
128
show apmanagement Shows the AP management configuration Exec
130
show system Displays system information Exec
130
show system resource Displays CPU and memory usage information Exec
131