User's Manual

Chapter 11 | System Management Commands
– 130 –
subnet-mask - Specifies a range of IP addresses allowed management
access.
Default Setting
All addresses
Command Mode
Global Configuration
Command Usage
◆ If anyone tries to access a management interface on the access point from an
invalid address, the unit will reject the connection, enter an event message in
the system log, and send a trap message to the trap manager.
◆ Management access applies to SNMP, HTTP (web), Telnet, and SSH connections.
Example
This example restricts management access to the specified addresses.
AP(config)#apmgmtip multiple 192.168.1.50 255.255.255.0
AP(config)#
show apmanagement This command shows the AP management configuration, including the IP
addresses of management stations allowed to access the AP, and the protocols that
are open to management access.
Command Mode
Exec
Example
AP#show apmanagement
=================================
AP Management IP Mode: static
Telnet UI: Enable
WEB UI : Enable
SNMP UI : Enable
==================================
AP#
show system This command displays basic system configuration settings.
Command Mode
Exec