User's Manual

– 139 –
12 System Logging Commands
These commands are used to configure system logging on the access point.
logging on This command controls logging of error messages; i.e., sending debug or error
messages to memory. The no form disables the logging process.
Syntax
[no] logging on
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
The logging process controls error messages saved to memory. You can use the
logging level command to control the type of error messages that are stored in
memory.
Example
AP(config)#logging on
AP(config)#
Table 7: System Management Commands
Command Function Mode Page
logging on Controls logging of error messages GC
139
logging host Adds a syslog server host IP address that will receive
logging messages
GC
140
logging console Initiates logging of error messages to the console GC
140
logging level Defines the minimum severity level for event logging GC
141
logging clear Clears all log entries in access point memory GC
141
show logging Displays the state of logging Exec
142
show event-log Displays all log entries in access point memory Exec
142