User's Manual

– 144 –
13 System Clock Commands
These commands are used to configure SNTP and system clock settings on the
access point.
sntp-server ip This command sets the IP address of the servers to which SNTP time requests are
issued. Use the this command with no arguments to clear all time servers from the
current list.
Syntax
sntp-server ip <1 | 2> <ip>
1 - First time server.
2 - Second time server.
ip - IP address of an time server (NTP or SNTP).
Default Setting
129.6.15.28
132.163.4.101
Command Mode
Global Configuration
Command Usage
When SNTP client mode is enabled using the sntp-server enabled command, the
sntp-server ip command specifies the time servers from which the access point
polls for time updates. The access point will poll the time servers in the order
specified until a response is received.
Table 9: System Clock Commands
Command Function Mode Page
sntp-server ip Specifies one or more time servers GC
144
sntp-server enabled Accepts time from the specified time servers GC
145
sntp-server date-time Manually sets the system date and time GC
145
sntp-server daylight-saving Sets the start and end dates for daylight savings
time
GC
146
sntp-server timezone Sets the time zone for the access point’s internal
clock
GC
147
show sntp Shows current SNTP configuration settings Exec
147