User's Manual

– 151 –
15 SNMP Commands
Controls access to this access point from management stations using the Simple
Network Management Protocol (SNMP), as well as the hosts that will receive trap
messages.
Table 11: SNMP Commands
Command Function Mode Page
snmp-server community Sets up the community access string to permit
access to SNMP commands
GC
152
snmp-server contact Sets the system contact string GC
152
snmp-server location Sets the system location string GC
153
snmp-server enable server Enables SNMP service and traps GC
153
snmp-server host Specifies the recipient of an SNMP notification
operation
GC
154
snmp-server trap Enables specific SNMP notifications GC
155
snmp-server vacm view Configures the VACM view GC
155
snmp-server vacm group Configures the VACM group GC
156
snmp-server user Sets the name of the SNMP v3 user GC
157
snmp-server target Configures SNMP v3 notification targets GC
158
snmp-server filter Configures SNMP v3 notification filters GC
159
show snmp vacm group Displays the VACM group Exec
163
show snmp vacm view Displays VACM views Exec
162
show snmp users Displays SNMP v3 user settings Exec
160
show snmp target Displays the SNMP v3 notification targets Exec
160
show snmp filter Displays the SNMP v3 notification filters Exec
161
show snmp Displays the status of SNMP communications Exec
161