User's Manual

Chapter 15 | SNMP Commands
– 155 –
Example
AP(config)#snmp-server host 1 10.1.19.23 batman
AP(config)#
Related Commands
snmp-server enable server
snmp-server trap This command enables the access point to send specific SNMP traps
(i.e., notifications). Use the no form to disable specific trap messages.
Syntax
snmp-server trap <trap>
no snmp-server trap <trap>
trap - One of the following SNMP trap messages:
sysSystemDown - The access point is about to shutdown and reboot.
sysSystemUp - The access point is up and running.
Default Setting
All traps enabled
Command Mode
Global Configuration
Command Usage
This command is used in conjunction with the snmp-server host and snmp-
server enable server commands to enable SNMP notifications.
Example
AP(config)#no snmp-server trap syssystemup
AP(config)#
snmp-server vacm
view
This command configures SNMP v3 views. Use the no form to delete an SNMP v3
view or remove a subtree from a filter.
Syntax
snmp-server vacm view <name> [included | excluded] <subtree> [mask
<mask>]
no snmp-server vacm view <name> [included | excluded] <subtree>
name - A user-defined name that identifies an SNMP v3 view. (Maximum
length: 32 characters)