User's Manual

Chapter 15 | SNMP Commands
– 161 –
Example
AP# show snmp target
Target List:
==================================
Target ID : christraps
IP Address : 192.168.1.33
User Name : chris
UDP Port : 4321
Filter ID : Not Defined
==================================
AP#
show snmp filter This command displays the SNMP v3 notification filter settings.
Syntax
show snmp filter [filter-id]
filter-id - A user-defined name that identifies an SNMP v3 notification filter.
(Maximum length: 32 characters)
Command Mode
Exec
Example
AP# show snmp filter
Filter List:
==================================
Filter: defaultfilter
Type: Included
Subtree: .1
Type: Excluded
Subtree: .1.3.6.1.2.1.2.2.1.1.23
Filter: testfilter
Type: Excluded
Subtree: .13.6.1.2.1.2.2.1.2
==================================
AP#
show snmp This command displays the SNMP configuration settings.
Command Mode
Exec