User's Manual

Chapter 15 | SNMP Commands
– 162 –
Example
AP# show snmp
SNMP Information
==============================================
Service State : Enable
Community (ro) : *******
Community (rw) : ********
Location : where?
Contact : who?
==============================================
Trap Destination List:
==============================================
Trap Destination: 192.168.1.22, Community : *****
==============================================
Trap Configuration:
==========================================================================
systemUp: Disabled systemDown: Disabled
==========================================================================
AP#
show snmp vacm view This command displays the configured SNMP v3 views.
Syntax
show snmp vacm view [view-name]
view-name - The name of a user-defined SNMPv3 view.
Command Mode
Exec
Example
AP# sh snmp vacm view
View List:
==================================
View Name : defaultview
Type : included
OID : .1
Mask :
View Name : testview
Type : included
OID : .1
Mask :
Type : excluded
OID : .13.6.1.2.1.2.2.1.2.1.1
Mask :
==================================
AP#