User's Manual

– 179 –
20 Filtering Commands
The commands described in this section are used to filter communications
between wireless clients, control access to the management interface from wireless
clients, and filter traffic using specific Ethernet protocol types.
filter local-bridge This command disables communication between wireless clients. Use the no form
to disable this filtering.
Syntax
filter local-bridge <all-VAP | intra-VAP>
no filter local-bridge
all-VAP - When enabled, clients cannot establish wireless communications
with any other client, either those associated to the same VAP interface or
any other VAP interface.
intra-VAP - When enabled, clients associated with a specific VAP interface
cannot establish wireless communications with each other. Clients can
communicate with clients associated to other VAP interfaces.
Default
Disabled
Table 16: Filtering Commands
Command Function Mode Page
filter local-bridge Disables communication between wireless clients GC
179
filter restrict-
management
Prevents wireless clients from accessing the
management interface
GC
180
filter dhcp Prevents wireless clients from accessing a DHCP
server
GC
180
filter acl-source-address Configures ACL filtering based on source MAC
addresses
GC
181
filter acl-destination-
address
Configures ACL filtering based on destination MAC
addresses
GC
181
filter ethernet-type
enable
Checks the Ethernet type for all incoming and
outgoing Ethernet packets against the protocol
filtering table
GC
182
filter ethernet-type
protocol
Sets a filter for a specific Ethernet type GC
182
show filters Shows the filter configuration Exec
183