User's Manual

Chapter 20 | Filtering Commands
– 183 –
protocol - An Ethernet protocol type. (Options: ARP, RARP, Berkeley-Trailer-
Negotiation, LAN-Test, X25-Level-3, Banyan, CDP, DEC XNS, DEC-MOP-
Dump-Load, DEC-MOP, DEC-LAT, Ethertalk, Appletalk-ARP, Novell-IPX(old),
Novell-IPX(new), EAPOL, Telxon-TXP, Aironet-DDP, Enet-Config-Test, IP, IPv6,
NetBEUI, PPPoE_Discovery, PPPoE_PPP_Session)
Default
None
Command Mode
Global Configuration
Command Usage
Use the filter ethernet-type enable command to enable filtering for Ethernet
types specified in the filtering table, or the no filter ethernet-type enable
command to disable all filtering based on the filtering table.
Example
AP(config)#filter ethernet-type protocol ARP
AP(config)#
Related Commands
filter ethernet-type enabled
show filters This command shows the filter options and protocol entries in the filter table.
Syntax
show filters [acl-source-address | acl-destination-address]
Command Mode
Exec
Example
AP#show filters
Protocol Filter Information
=======================================================================
Local Bridge :Traffic among all client STAs blocked
AP Management :DISABLED
EtherType Filter :DISABLED
Enabled EtherType Filters
-----------------------------------------------------------------------
=======================================================================
AP#