User's Manual

– 185 –
21 Spanning Tree Commands
The commands described in this section are used to set the MAC address table
aging time and spanning tree parameters for both the Ethernet and wireless
interfaces.
Table 17: Spanning Tree Commands
Command Function Mode Page
bridge stp service Enables the Spanning Tree feature GC
186
bridge stp br-conf
forwarding-delay
Configures the spanning tree bridge forward time GC
186
bridge stp br-conf hello-time Configures the spanning tree bridge hello time GC
187
bridge stp br-conf max-age Configures the spanning tree bridge maximum
age
GC
187
bridge stp br-conf priority Configures the spanning tree bridge priority GC
188
bridge stp port-conf
interface
Enters STP interface configuration mode GC
188
bridge-link path-cost Configures the spanning tree path cost for the
Ethernet port
IC-E
189
bridge-link port-priority Configures the spanning tree priority for the
Ethernet port
IC-E
189
vap Selects the VAP interface in STP interface
configuration mode
GC-STP
190
path-cost Sets the path cost for a VAP interface in STP
interface configuration mode
GC-STP
190
port-priority Sets the port priority for a VAP interface in STP
interface configuration mode
GC-STP
191
bridge mac-aging Sets the MAC address aging time GC
191
show bridge stp Displays the global spanning tree settings Exec
192
show bridge br-conf Displays spanning tree settings for specified
VLANs
Exec
192
show bridge port-conf Displays spanning tree settings for specified
interfaces
Exec
193
show bridge status Displays STP bridge status for a specified VLAN or
all VLANs
Exec
194
show bridge forward address Displays STP settings for forwarding MAC
addesses on specified interfaces or VLANs
Exec
195
show bridge mac-aging Displays the current MAC address table aging time Exec
196