User's Manual

Chapter 21 | Spanning Tree Commands
– 189 –
Command Usage
Use this command to enter STP interface configuration mode. In this mode STP
settings for specific VAP interfaces can be configured.
Example
AP(config)# bridge stp port-conf interface wireless 0
Enter Wireless configuration commands, one per line.
AP(stp-if-wireless 0)#
bridge-link path-cost Use this command to configure the spanning tree path cost for the Ethernet port.
Syntax
bridge-link path-cost <cost>
cost - The path cost for the port. (Range: 1-65535)
Default Setting
4
Command Mode
Interface Configuration (Ethernet)
Command Usage
◆ This command is used by the Spanning Tree Protocol to determine the best
path between devices. Therefore, lower values should be assigned to ports
attached to faster media, and higher values assigned to ports with slower
media.
◆ Path cost takes precedence over port priority.
Example
AP(if-wireless a)#bridge-link path-cost 1 50
AP(if-wireless a)#
bridge-link port-
priority
Use this command to configure the priority for the Ethernet port.
Syntax
bridge-link port-priority <priority>
priority - The priority for a port. (Range: 1-255)
Default Setting
32