User's Manual
Chapter 21
| Spanning Tree Commands
– 190 –
Command Mode
Interface Configuration (Ethernet)
Command Usage
◆ This command defines the priority for the use of a port in the Spanning Tree
Protocol. If the path cost for all ports on a wireless bridge are the same, the port
with the highest priority (that is, lowest value) will be configured as an active
link in the spanning tree.
◆ Where more than one port is assigned the highest priority, the port with lowest
numeric identifier will be enabled.
Example
AP(if-wireless a)#bridge-link port-priority 1 64
AP(if-wireless a)#
Related Commands
bridge-link path-cost
vap (STP Interface) This command selects the VAP interface for configuring STP settings.
Syntax
vap <vap-index>
vap-index - The index number for the VAP interface. (Range: 0-7)
Command Mode
Global Configuration (STP interface)
Example
AP(stp-if-wireless 0)# vap 0
AP(stp-if-wireless 0: VAP[0])#
path-cost (STP
Interface)
This command sets the spanning tree path cost for the VAP interface.
Syntax
path-cost <cost>
cost - The path cost for the VAP interface. (Range: 1-65535)
Command Mode
Global Configuration (STP interface)