User's Manual

– 199 –
23 Ethernet Interface Commands
The commands described in this section configure connection parameters for the
Ethernet port and wireless interface.
interface ethernet This command enters Ethernet interface configuration mode.
Default Setting
None
Command Mode
Global Configuration
Example
To specify the 1000BASE-T network interface, enter the following command:
AP(config)#interface ethernet
AP(if-ethernet)#
Table 19: Ethernet Interface Commands
Command Function Mode Page
interface ethernet Enters Ethernet interface configuration mode GC
199
dns Specifies the primary and secondary name servers IC-E
200
ip address Sets the IP address for the Ethernet interface IC-E
200
ip dhcp Submits a DHCP request for an IP address IC-E
201
ip management address Sets a static IP address for management access IC-E
202
ipv6 address Sets the IPv6 address for the Ethernet interface IC-E
202
ipv6 dhcp Submits a DHCPv6 request for an IPv6 address IC-E
203
shutdown Disables the Ethernet interface IC-E
204
show interface ethernet Shows the status for the Ethernet interface Exec
205