User's Manual

– 206 –
24 Wireless Interface Commands
The commands described in this section configure connection parameters for the
wireless interfaces.
Table 20: Wireless Interface Commands
Command Function Mode Page
interface wireless Enters wireless interface configuration mode GC
208
vap Provides access to the VAP interface configuration
mode
IC-W
208
a-mpdu Sets the Aggregate MAC Protocol Data Unit (A-
MPDU)
IC-W
209
a-msdu Sets the Aggregate MAC Service Data Unit (A-
MSDU)
IC-W
209
channel Configures the radio channel IC-W
210
transmit-power Adjusts the power of the radio signals transmitted
from the access point
IC-W
211
min-allowed-rate Selects minimum allowed transmit data rates IC-W
212
disable-coexist Prevents 20 MHz and 40 MHz channels operating
together
IC-W
212
make-rf-setting-
effective
Implements wireless command changes made in
current CLI session
IC-W
213
preamble Sets the length of the 802.11g signal preamble IC-W
213
short-guard-interval Enables the 802.11n short guard interval IC-W
214
beacon-interval Configures the rate at which beacon signals are
transmitted from the access point
IC-W
214
dtim-period Configures the rate at which stations in sleep mode
must wake up to receive broadcast/multicast
transmissions
IC-W
215
rts-threshold Sets the packet size threshold at which an RTS must
be sent to the receiving station prior to the sending
station starting communications
IC-W
216
ssid Configures the service set identifier IC-W-VAP
217
closed system Opens access to clients without a pre-configured
SSID
IC-W-VAP
217
max-client Sets the maximum number of clients per radio IC-W
218
max-association Sets the maximum number of clients per VAP IC-W-VAP
218
client-assoc-preempt Implements a priority for associating clients IC-W-VAP
219