User's Manual

Chapter 24 | Wireless Interface Commands
– 207 –
assoc- timeout-interval Configures the idle time interval (when no frames
are sent) after which a client is disassociated from
the VAP interface
IC-W-VAP
220
auth- timeout-value Configures the time interval after which clients
must be re-authenticated
IC-W-VAP
220
multicast-enhance Enhances multicast quality for wireless clients IC-W-VAP
221
shutdown Disables the wireless interface IC-W-VAP
221
interfere-chan-recover Rescans channels when interference is detected IC-W
222
band-steering Redirects all dual-band clients to connect to the
5GHz radio
GC
222
wlandev-interfere-
detection
Enables the detection of interference from nearby
APs
IC-W
223
antenna-chain Sets the internal antennas to use IC-W
223
long-distance Enables long distance parameter settings IC-W
224
long-distance reference-
data
Computes settings from a distance reference IC-W
225
long-distance slottime Sets the slot time parameter IC-W
225
long-distance
acktimeout
Sets the acknowledge timeout parameter IC-W
226
long-distance
ctstimeout
Sets the CTS timeout parameter IC-W
226
bandwidth-control
downlink
Enables downlink bandwidth control on a VAP
interface
IC-W-VAP
226
bandwidth-control
downlink rate
Sets the downlink bandwidth rate for a VAP
interface
IC-W-VAP
227
bandwidth-control
uplink
Enables uplink bandwidth control on a VAP
interface
IC-W-VAP
228
bandwidth-control
uplink rate
Sets the uplink bandwidth rate for a VAP interface IC-W-VAP
228
show interface wireless Shows the status for the wireless interface Exec
229
show station Shows the wireless clients associated with the
access point
Exec
231
show station statistics Shows traffic statistics for wireless clients associated
with the access point
Exec
232
show band-steering Shows the status of the Band Steering feature Exec
233
Table 20: Wireless Interface Commands (Continued)
Command Function Mode Page