User's Manual

Chapter 24 | Wireless Interface Commands
– 211 –
Example
AP(if-wireless 0)# channel ht20 06
This setting has not been effective !
If want to take effect, please execute make-RF-setting-effective command !
AP(if-wireless 0)#
transmit-power This command adjusts the power of the radio signals transmitted from the access
point.
Syntax
transmit-power {percentage <percent-power> | dbm <dbm-power>}
percent-power - Signal strength as a percentage transmitted from the AP.
(Options: full, half, quarter, eighth, min)
dbm-power - Signal strength in dBm transmitted from the AP.
(Range: 3-20 dBm)
Default Setting
Percentage Mode: Full (100%)
dBm Mode: 18 dBm
Command Mode
Interface Configuration (Wireless)
Command Usage
◆ The “min” keyword indicates minimum power.
◆ The longer the transmission distance, the higher the transmission power
required. But to support the maximum number of users in an area, you must
keep the power as low as possible. Power selection is not just a trade off
between coverage area and maximum supported clients. You also have to
ensure that high strength signals do not interfere with the operation of other
radio devices in your area.
Example
AP(if-wireless 0)# transmit-power percentage half
AP(if-wireless 0)#