User's Manual

Chapter 24 | Wireless Interface Commands
– 213 –
Example
AP(if-wireless 0)# disable-coexist y
AP(if-wireless 0)#
make-rf-setting-
effective
This command implements all wireless command changes made in current CLI
session.
Syntax
make-rf-setting-effective
Command Mode
Interface Configuration (Wireless)
Example
AP(if-wireless 0)# make-RF-setting-effective
It will take several minutes !
Please wait a while...
AP(if-wireless 0)#
preamble This command sets the length of the signal preamble that is used at the start of a
802.11b/g data transmission.
Syntax
preamble [long | short-or-long]
long - Sets the preamble to long (192 microseconds).
short-or-long - Sets the preamble to short if no 802.11b clients are
detected (96 microseconds).
Default Setting
Short-or-Long
Command Mode
Interface Configuration (Wireless)
Command Usage
◆ Using a short preamble instead of a long preamble can increase data
throughput on the access point, but requires that all clients can support a short
preamble.