User's Manual

Chapter 24 | Wireless Interface Commands
– 217 –
ssid This command configures the service set identifier (SSID) of the VAP.
Syntax
ssid <string>
string - The name of a basic service set supported by the access point.
(Range: 1 - 32 characters)
Default Setting
2.4 GHz: EAP9112A_11BGN_0 to 15 (for VAPs 0-15)
5 GHz: EAP9112A_11NA_0 to 15 (for VAPs 0-15)
Command Mode
Interface Configuration (Wireless-VAP)
Command Usage
Clients that want to connect to the wireless network through an access point must
set their SSIDs to the same as that of the access point.
Example
AP(if-wireless 0: VAP[0])# ssid net-name
This setting has not been effective !
If want to take effect, please execute make-security-effective command !
AP(if-wireless 0: VAP[0])#
closed-system This command prohibits access to clients without a pre-configured SSID. Use the
no form to disable this feature.
Syntax
[no] closed-system
Default Setting
Disabled
Command Mode
Interface Configuration (Wireless-VAP)
Command Usage
When closed system is enabled, the access point will not include its SSID in beacon
messages. Nor will it respond to probe requests from clients that do not include a
fixed SSID.