User's Manual

Chapter 24 | Wireless Interface Commands
– 219 –
Default Setting
127
Command Mode
Interface Configuration (Wireless-VAP)
Command Usage
This command sets the total maximum number of clients that may associate with a
VAP interface. If the value is greater than the setting for the maximum clients per
radio (max-client command), the command does not take effect.
Example
AP(if-wireless 0: VAP[0])# max-association 64
AP(if-wireless 0: VAP[0])#
client-assoc-preempt This command enables a feature that implements a priority for associating clients
when the maximum has been reached. Use the no form to disable the feature.
Syntax
[no] client-assoc-preempt
Default Setting
Disabled
Command Mode
Interface Configuration (Wireless-VAP)
Command Usage
◆ When enabled, the AP applies a priority order for associating clients when the
maximum clients for the VAP has been reached. The priority order is 11n clients,
11a/g clients, then 11b clients.
◆ When the association pool for the VAP is full and the AP receives an association
request from a high-priority (11n) client, the AP sends a disassociation to a
lower priority client (11a/g or 11b) in order to be able to associate the high-
priority client. If there are no lower-priority clients to disassociate, the AP will
reject the association request.
Example
AP(if-wireless 0: VAP[0])# client-assoc-preempt
set_vap_assoc_pri 0 0 y
This setting has not been effective !
If want to take effect, please execute make-security-effective command !
AP(if-wireless 0: VAP[0])#