User's Manual

Chapter 1 | Introduction
Connecting to the Web Interface
– 22 –
To configure settings, click the relevant Main Menu item. Each Main Menu item is
sumarized below with links to the relevant section in this guide where
configuration parameters are described in detail:
◆ System — Configures Management IP, WAN, LAN and QoS settings. See
“System Settings” on page 33.
◆ Administration — Configures HTTP, Telnet, and SSH access settings. See
“Management Settings” on page 49.
◆ Advanced — Confiures LLDP and Access Control Lists. See “Advanced Settings”
on page 60.
◆ Wireless — Configures AP radio settings. See “Wireless Settings” on page 67.
◆ SNMP — Configures SNMP settings. See “Management Settings” on page 49.
◆ Maintentance — Enables firmware upgrades and resets the AP. See
“Maintenance Settings” on page 91.
◆ Information — Displays current system settings. See “Status Information” on
page 97.
Common Web Page
Buttons
The list below describes the common buttons found on most web management
pages:
◆ Set – Applies the new parameters and saves them to temporary RAM memory.
Also displays a screen to inform you when it has taken affect. Clicking ‘OK’
returns to the home page. The running configuration will not be saved upon a
reboot unless you use the “Save Config” button.
Figure 3: Set Configuration Changes
◆ Cancel – Cancels the newly entered settings and restores the originals.
◆ Help – Displays the help window.