User's Manual

Chapter 24 | Wireless Interface Commands
– 222 –
interfere-chan-
recover
This command rescans channels when interference is detected on the current
channel. Use the no form to disable the feature.
Syntax
[no] interfere-chan-recover
Default Setting
Disabled
Command Mode
Interface Configuration (Wireless)
Command Usage
◆ When interference is detected on the current channel, the AP re-scans all
channels and then changes to a new clear channel.
◆ There is too much interference on a channel when the AP is unable to send the
beacon signal more than ten times. The AP will then use its auto-channel
algorithm to find a new clear channel.
Example
AP(if-wireless 0)# interfere-chan-recover
AP(if-wireless 0)#
band-steering This command redirects all dual-band clients to connect to the 5 GHz radio. Use the
no form to disable the feature.
Syntax
[no] band-steering
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
◆ The Band Steering feature redirects all dual-band clients associated to the
2.4 GHz radio to connect to the 5 GHz radio.
◆ This feature only functions when both the 2.4 GHz and 5 GHz radio SSIDs are
identical.