User's Manual

Chapter 24 | Wireless Interface Commands
– 223 –
Example
AP(config)# band-steering
AP(config)#
wlandev-interfere-
detection
This command enables the detection of nearby APs that are using the same
channel. Use the no form to disable the feature.
Syntax
wlandev-interfere-detection <rssi> <time>
[no] wlandev-interfere-detection
rssi - The RSSI signal strength threshold of a nearby AP above which the unit
switches to another channel. (Range: 1-100)
time - The time duration that a nearby AP with an RSSI above the set
threshold is continuously detected before the unit restarts the scan
process. (Range: 10-300 seconds)
Default Setting
Disabled
RSSI: 80
Time: 30 seconds
Command Mode
Interface Configuration (Wireless)
Command Usage
Enables the detection of nearby APs that are using the same channel. If the RSSI
signal strength of a nearby AP is above the configured threshold value for more
than the specified time, the unit switches to another channel.
Example
AP(if-wireless 0)# wlandev-interfere-detection 90 60
AP(if-wireless 0)#
antenna-chain This command selects the use of two antennas or a single antenna for radio
transmissions.
Syntax
antenna-chain <right-left | left | right>
right-left - The radio transmits from both internal antennas.
left - The radio only transmits from one internal antenna.
right - The radio only transmits from one internal antenna.