User's Manual

Chapter 24 | Wireless Interface Commands
– 224 –
Default Setting
right-left
Command Mode
Interface Configuration (Wireless)
Example
AP(if-wireless 0)# antenna-chain left
This setting has not been effective !
If want to take effect, please execute make-RF-setting-effective command !
AP(if-wireless 0)#
long-distance This command computes settings that allow wireless clients a long distance from
the AP to maintain communications.
Syntax
long-distance <enable | disable>
enable - Enables the long distance settings.
disable - Disables the feature.
Default
Disabled
Command Mode
Interface Configuration (Wireless)
Command Usage
When you have long-distance links in the wireless network, some timing
parameters require an adjustment to maintain communications. You can enable
this feature and then use the long-distance reference-data command to suggest
settings based on an approximate distance.
Example
AP(if-wireless 0)# long-distance enable
For making changes effective, please execute make-RF-setting-effective
command !
AP(if-wireless 0)#