User's Manual

Chapter 24 | Wireless Interface Commands
– 226 –
long-distance
acktimeout
This command sets the acknowledge timeout for long-distance communications.
Syntax
long-distance acktimeout <timeout>
timeout - The adjusted acknowledge timeout in microseconds.
Default
64 microseconds
Command Mode
Interface Configuration (Wireless)
Example
AP(if-wireless 0)# long-distance acktimeout 56
For making changes effective, please execute make-RF-setting-effective
command after entering all three long distance parameters!
AP(if-wireless 0)#
long-distance
ctstimeout
This command sets the CTS (clear to send) timeout for long-distance
communications.
Syntax
long-distance ctstimeout <timeout>
timeout - The adjusted CTS timeout in microseconds.
Default
48 microseconds
Command Mode
Interface Configuration (Wireless)
Example
AP(if-wireless 0)# long-distance ctstimeout 56
For making changes effective, please execute make-RF-setting-effective
command after entering all three long distance parameters!
AP(if-wireless 0)#
bandwidth-control
downlink
This command enables the downlink bandwidth control for a VAP interface.
Syntax
bandwidth-control downlink <enable | disable>
enable - Enables the downlink bandwidth control setting.