User's Manual

Chapter 24 | Wireless Interface Commands
– 227 –
disable - Disables the feature.
Default
Disabled
Command Mode
Interface Configuration (Wireless-VAP)
Command Usage
This command enables the rate limiting of traffic from the wired network as it is
passed to the VAP interface. You can set a maximum rate in Kbytes per second.
Example
AP(if-wireless 0: VAP[0])# bandwidth-control downlink enable
This setting has not been effective !
If want to take effect, please execute make-security-effective command !
AP(if-wireless 0: VAP[0])#
bandwidth-control
downlink rate
This command sets the downlink bandwidth rate for a VAP interface.
Syntax
bandwidth-control downlink rate <rate>
rate - The allowed downlink rate in Kbytes per second.
(Range: 100-12000 Kbytes per second)
Default
100 Kbytes per second
Command Mode
Interface Configuration (Wireless-VAP)
Example
AP(if-wireless 0: VAP[0])# bandwidth-control downlink rate 512
This setting has not been effective !
If want to take effect, please execute make-security-effective command !
AP(if-wireless 0: VAP[0])#