User's Manual

Chapter 24

| Wireless Interface Commands

– 228 –

bandwidth-control

uplink

This command enables the uplink bandwidth control for a VAP interface.

Syntax

bandwidth-control uplink <enable | disable>

enable - Enables the uplink bandwidth control setting.

disable - Disables the feature.

Default

Disabled

Command Mode

Interface Configuration (Wireless-VAP)

Command Usage

This command enables the rate limiting of traffic from the VAP interface as it is

passed to the wired network. You can set a maximum rate in Kbytes per second.

Example

AP(if-wireless 0: VAP[0])# bandwidth-control uplink enable

This setting has not been effective !

If want to take effect, please execute make-security-effective command !

AP(if-wireless 0: VAP[0])#

bandwidth-control

uplink rate

This command sets the uplink bandwidth rate for a VAP interface.

Syntax

bandwidth-control uplink rate <rate>

rate - The allowed uplink rate in Kbytes per second.

(Range: 100-12000 Kbytes per second)