User's Manual

Chapter 24 | Wireless Interface Commands
– 229 –
AP(if-wireless 0: VAP[0])#
show interface
wireless
This command displays the status for a specified VAP interface.
Syntax
show interface wireless <index> vap <vap-index>
index - The wireless interface slot number. (Range: 0 or 1)
vap-index - The number that identifies a VAP interface.
(Options: 0-15)
Command Mode
Exec
Example
AP# show interface wireless 0 vap 0
----------------------------------Basic Setting----------------------------
SSID : EAP9112A_11BGN_0
Wireless Network Mode : 11ng
Auto Channel Select : ENABLE
Channel : 1
Channel Width Mode : HT20
Allowed Rates : 1,2,5.5,11,6,9,12,18,24,36,48,54,
MCS0,MCS1,MCS2,MCS3,MCS4,MCS5,MCS6,
MCS7,MCS8,MCS9,MCS10,MCS11,MCS12,
MCS13,MCS14,MCS15
Status : ENABLE
Multicast enhancement : DISABLE
MAC Address : 70:72:CF:00:11:70
VLAN-ID : 1
Dhcp-Relay Server Ip : 0.0.0.0
----------------------------------Capacity----------------------------------
Maximum Association Client Per Vap : 16 Clients
Maximum Association Client Per Radio : 127 Clients
------------------------------802.11 Parameters-----------------------------
Transmit Power : 100%(20 dBm)
Preamble Length : Short-or-Long
Fragmentation Threshold : 2346
RTS Threshold : 2346
Beacon Interval : 100
Authentication Timeout Interval : 3 Mins
Association Timeout Interval : 5 Mins
DTIM Interval : 1
Short Guard Interval Status : Disabled
A-MPDU Status : Enabled
A-MPDU Length Limit : 65535 Bytes
A-MSDU Status : Enabled
Disable HT20/H40 coexistence : disabled
Interference Channel Recover : disabled
-----------------------Press any key to continue-----------------------
WLAN Device Interference Detection : disabled
WLAN client association preemption : disabled