User's Manual

Chapter 26 | Rogue AP Detection Commands
– 246 –
Command Mode
Interface Configuration (Wireless)
Command Usage
◆ During a scan, client access may be disrupted and new clients may not be able
to associate to the access point. If clients experience severe disruption, reduce
the scan duration time.
◆ A long scan duration time will detect more access points in the area, but causes
more disruption to client access.
Example
AP(if-wireless 0)#rogue-ap duration 200
AP(if-wireless 0)#
Related Commands
rogue-ap interval (246)
rogue-ap interval This command sets the interval at which to scan for access points.
Syntax
rogue-ap interval <seconds>
seconds - The interval between consecutive scans. (Range: 15-65535
seconds)
Default Setting
7200 seconds
Command Mode
Interface Configuration (Wireless)
Command Usage
This command sets the interval at which scans occur. Frequent scanning will more
readily detect other access points, but will cause more disruption to client access.
Example
AP(if-wireless 0)#rogue-ap interval 120
AP(if-wireless 0)#
Related Commands
rogue-ap duration (245)