User's Manual

Chapter 28 | Link Layer Discovery Commands
– 254 –
Example
AP(config)# lldp transmit interval 30
AP(config)#
lldp transmit re-init-
delay
This command configures the delay before attempting to re-initialize after LLDP
ports are disabled or the link goes down.
Syntax
lldp transmit re-init-delay <seconds>
seconds - Time in seconds. (Range: 2 - 10)
Default Setting
2 seconds
Command Mode
Global Configuration
Command Usage
◆ This command configures the delay before attempting to re-initialize after
LLDP ports are disabled or the link goes down.
◆ When LLDP is re-initialized on a port, all information in the remote systems
LLDP MIB associated with this port is deleted.
Example
AP(config)#lldp transmit re-init-delay 10
AP(config)#
lldp transmit delay-to-
local-change
This command configures a delay between the successive transmission of LLDP
advertisements initiated by a change in local LLDP MIB variables.
Syntax
lldp transmit delay-to-local-change <seconds>
seconds - Time in seconds. (Range: 1-8192 seconds)
Default Setting
2 seconds
Command Mode
Global Configuration