User's Manual

Chapter 4 | Management Settings
Simple Network Management Protocol
– 59 –
The following items are displayed on this page:
◆ Filter ID — A user-defined name that identifies the filter. (Maximum length: 32
characters)
◆ Subtree — Specifies MIB subtree to be filtered. The MIB subtree must be
defined in the form “.1.3.6.1” and always start with a “.”.
◆ Type — Indicates if the filter is to “include” or “exclude” the MIB subtree objects
from the filter. Note that MIB objects included in the filter are not sent to the
receiving target and objects excluded are sent. By default all traps are sent, so
you can first use an “include” filter entry for all trap objects. Then use “exclude”
entries for the required trap objects to send to the target. Note that the filter
entries are applied in the sequence that they are defined.
◆ Action — Adds the notification filter.