User's Manual

Chapter 6 | Wireless Settings
Rogue AP Detection
– 85 –
where any rogue APs can be identified. Rogue access points can be identified by
unknown BSSID (MAC address).
Figure 45: Rogue AP Detection
The following items are displayed on this page:
◆ AP Scan Setting — Enables the periodic scanning for other nearby access
points. (Default: Disable)
◆ Scan Interval — Sets the time between each rogue AP scan. (Range: 15 -65535
seconds; Default: 7200 seconds)
◆ Scan Duration — Sets the length of time for each rogue AP scan. A long scan
duration time will detect more access points in the area, but causes more
disruption to client access. (Range: 10 -150 milliseconds; Default: 150
milliseconds)
◆ First Scan Delay — Delays the start of rogue AP scanning after enabling the
feature or booting the AP. (Range: 0 -65535 seconds; Default: 65535 seconds)
◆ Friendly AP — Allows you to enter the MAC address/Basic Service Set Identifier
(BSSID) of known APs in the network. These MAC addresses will be filtered out
of the list of detected APs during a scan.