User's Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Basic Setup
- Chapter 3 Viewing Live Video
- Chapter 4 Advanced Viewing Setup
- Chapter 5 Web-based Management
- Introduction
- Connecting to Network Camera
- Welcome Screen
- Administration Menu
- System Screen
- Network Screen
- Wireless Screen (Wireless Model Only)
- DDNS Screen
- Video & Audio Screen
- Video Access Screen
- User Database Screen
- Motion Detection Screen
- E-Mail Screen
- FTP Screen
- HTTP Screen
- Event Trigger Screen
- Maintenance Screen
- Status Screen
- Log Screen
- Chapter 6 WindowsViewing/Recording Utility
- Chapter 7 Troubleshooting
- Appendix A Specifications
- Appendix B Streaming Video/Audio Solution
Camera Data - LAN
Local ID
This is the name you gave to this camera. This field must be entered.
Device ID
This is the default name for the Wireless Network Camera, and cannot
be changed.
IP Address
The current IP address of the Wireless Network Camera.
Port Number
This will normally display "80". Only change this if requested to do so
by the Wireless Network Camera Administrator.
Login
The camera Administrator can require that users provide a username and
password before being allowed to view the live video.
• If the Administrator has not enabled this option, the Login fields can
be left blank.
• Otherwise, you must enter the username and password allocated to
your by Administrator.
Stream Type
Select the desired type from the drop-down list.
Setup Camera
Pages
Click this button to connect the Web-based interface of the Camera
Enable Trigger
Event
Check this if you want the Utilities to enable motion triggered recording.
Note: Event trigger setting in the camera must also be enabled to let the
event triggered recording of Utilities take effect.
You can add the same Camera twice, once for the LAN (using
the LAN IP address), and again for the Internet (using the
Internet IP address). This will allow viewing the camera whether
you are on the same LAN as the camera or in a remote location.
65