Datasheet

Face seal
Applicable Tubing
Tubing material FEP, PFA, Nylon, Soft nylon, Polyurethane
Tubing O.D. Ø 4, Ø 6
Specifications
Fluid
Air, Water
∗
1
Operating pressure range
∗
2
-100 kPa to 1 MPa
Proof pressure (at 23 °C)
3 MPa
Ambient and fluid temperature
-5 to 60 °C, Water: 0 to 40 °C
(No freezing)
Thread
Mounting section
ISO 16030 (Parallel pipe thread)
Nut section
JIS B0205 (Metric fine thread)
Sealant on the threads
Seal ring
∗1 The surge pressure must be under the maximum operating pressure.
∗2 Do not use the fittings with a leak tester or for vacuum retention because they are not guaranteed for zero
leakage.
Principal Parts Material
Body C3604, PBT
Stud C3604 (Thread portion)
Chuck Stainless steel 304
Guide Stainless steel 304
Release button POM
Seal, O-ring, Seal ring NBR
Suitable for use with nylon and
urethane. Large retaining force.
The chuck provides secure retention and the
collet increases the holding force on the tube.
Requires little force
for removal.
Releases the chuck collet to
remove the tube as well as to
prevent the chuck from biting
too deeply into the tubing.
Effective when piping in
a confined space.
The body and the threaded portion can rotate
(for positioning to some extent).
Seal
Stud
Release button
O-ring
Body
Piping installability is improved by
changing to the face seal structure.
Seal ring
Chuck
Guide
Applicable to parallel
pipe thread (G).
Drastically reduces
screw-in time with the
face seal method.
G thread
Metric Size One-touch Fittings
Applicable Tubing: Metric Size, Connection Thread: G
Face seal method
Can be used for a wide range of
pressures from a low vacuum
up to a pressure of 1 MPa.
The use of a special profile ensures
sealing and reduces resistance when
the tube is inserted.
KQ2 Series
Oval Type
57