User Guide
Doc. No. SF
∗-OMZ0013-A
-6-
Operating Environment
Warning
1. Do not operate under the conditions listed below due to a risk of malfunction.
- In locations containing corrosive gases, organic solvents, and chemical solutions, or in locations
in which these elements are likely to adhere to the equipment
- In locations in which sea water, water, or water steam could come in contact with the equipment
- In locations that are exposed to direct sunlight (Shield the equipment from sunlight to prevent
its resin material from ultraviolet ray degradation or overheating.)
- In locations that have a heat source and poor ventilation (Shield the equipment from heat
sources to protect it from softening degradation due to radiated heat.)
- In locations that are exposed to shocks and vibrations
- In locations with high humidity or large amounts of dust
2. When the product is used for blowing, use caution to prevent the work from being damaged by
entrained air from the surrounding area.
If compressed air is used for air blow, compressed air blowing out from the blow nozzle may entrain
foreign matter (solid particles and liquid particles) floating in the ambient air, blowing it against the
workpieces and causing adhesion. Therefore, sufficient precautions must be taken about the
ambient environment.
Mounting
Warning
1. Flushing
- Flush and clean the piping before installing the product. Dust and foreign matter left in the piping
can cause operating failure and malfunction.
- When connecting pipework, flush before initial use and element replacement to reduce particle
generation. After that, start main operation.
2. Unpacking the sealed package
Since the filter is sealed in an antistatic double bag, the inner package should be unpacked in a
clean atmosphere (such as a clean room).
3. Piping ports
- When connecting pipework, apply a wrench across the flats of the IN or OUT side to prevent the
main body from rotating.
- Connect the piping in accordance with the flow direction marked on the case.
If connected in reverse, the element could break.
4. Installation
Secure the product with the brackets included in the packaging.
2021-09-1615:31
DP 097499