User guide

System Configuration
5-52
CLI Commands for WEP Shared Key Security – From the
802.11g interface configuration mode, use the authentication
command to enable WEP shared-key authentication and the
encryption command to enable WEP encryption. Use the
multicast-cipher command to select WEP cipher type. To enter
WEP keys, use the
key command, and then set one key as the
transmit key using the
transmit-key command. Then disable
802.1x port authentication with the
802.1x command. To view the
current security settings, use the
show interface wireless g
command.
SMC-AP(config)#interface wireless g 6-68
Enter Wireless configuration commands, one per line.
SMC-AP(if-wireless g)#authentication shared 6-82
SMC-AP(if-wireless g)#encryption 128 6-83
SMC-AP(if-wireless g)#multicast-cipher wep 6-88
SMC-AP(if-wireless g)#key 1 128 ascii abcdeabcdeabc 6-84
SMC-AP(if-wireless g)#transmit-key 1 6-85
SMC-AP(if-wireless g)#end
SMC-AP(config)#no 802.1x 6-51
SMC-AP(config)#end
SMC-AP#show interface wireless g 6-95
Wireless Interface 802.11g Information
==========================================================
----------------Identification----------------------------
Description : Enterprise 802.11g Access Point
SSID : r&d
Channel : 11 (AUTO)
Status : Enable
----------------802.11 Parameters-------------------------
Transmit Power : HALF (10 dBm)
Max Station Data Rate : 54Mbps
Fragmentation Threshold : 2346 bytes
RTS Threshold : 2347 bytes
Beacon Interval : 100 TUs
DTIM Interval : 2 beacons
Maximum Association : 32 stations