User guide

Introduction
1-4
Component Description
Antennas
The access point includes two antennas for wireless
communications. The signal transmitted from both antennas is
identical, but only the best signal received on one of the antennas
is used. The antennas transmit the outgoing signal as a toroidal
sphere, so the antennas should be adjusted to different angles to
provide better coverage. For further information, see “Positioning
the Antennas” on page 2-3.
LED Indicators
The access point includes
three status LED indicators,
as described in the following
figure and table.
LED Status Description
PWR Off No power.
On Green Power on and ready for operation.
On Amber H/W error or system error.
Blinking
Green (Slow)
Indicates one of the following:
• running the power-on self-test
• loading new software
LAN Off Indicates no valid Ethernet cable link on
the RJ-45 port, or that the port has been
administratively disabled
On/Flashing
Green
Indicates a valid 100 Mbps link on the
RJ-45 port. Flashing indicates activity.
On/Flashing
Amber
Indicates a valid 10 Mbps link on the
RJ-45 port. Flashing indicates activity.
WLAN
LAN
Power
802.11g
Wireless
Link/Activity
Ethernet
Link/Activity