User guide

System Configuration
5-38
changes. To use this feature you must define the month and date
to begin and to end the change from standard time. During this
period the system clock is set back by one hour.
CLI Commands for SNTP – To enable SNTP support on the
access point, from the global configuration mode specify SNTP
server IP addresses using the sntp-server ip command, then
use the sntp-server enable command to enable the service. Use
the sntp-server timezone command to set the time zone for your
location, and the sntp-server daylight-saving command to set
daylight savings. To view the current SNTP settings, use the
show sntp command.
SMC-AP(config)#sntp-server ip 10.1.0.19 6-28
SMC-AP(config)#sntp-server enable 6-29
SMC-AP(config)#sntp-server timezone +8 6-32
SMC-AP(config)#sntp-server daylight-saving 6-31
Enter Daylight saving from which month<1-12>: 3
and which day<1-31>: 31
Enter Daylight saving end to which month<1-12>: 10
and which day<1-31>: 31
SMC-AP(config)#exit
SMC-AP#show sntp 6-32
SNTP Information
=========================================================
Service State : Enabled
SNTP (server 1) IP : 137.92.140.80
SNTP (server 2) IP : 192.43.244.18
Current Time : 19 : 35, Jan 10th, 2004
Time Zone : +8 (TAIPEI, BEIJING)
Daylight Saving : Enabled, from Mar, 31th to Oct,
31th
=========================================================
SMC-AP#