Datasheet

Configuring the Switch
3-30
3
CLI – Enter the host ip address, followed by the mail severity level, source and
destination email addresses and enter the sendmail command to complete the
action. Use the show logging command to display SMTP information.
Renumbering the System
Web – Click System, Renumber. Click the Renumber button to renumber the switch.
When prompted, confirm that you want to renumber the switch.
Figure 3-20 Renumbering the System
CLI – Use the reload command to restart the switch. When prompted, confirm that
you want to reset the switch.
When restarting the system, it will always run the Power-On Self-Test.
Resetting the System
Web – Click System, Reset. Click the Reset button to reboot the switch. When
prompted, confirm that you want reset the switch.
Figure 3-21 Resetting the System
CLI – Use the reload command to restart the switch. When prompted, confirm that
you want to reset the switch.
Note:
When restarting the system, it will always run the Power-On Self-Test.
Console#reload 4-22
System will be restarted, continue <y/n>? y
Console(config)#logging sendmail host 192.168.1.19
Console(config)#logging sendmail level 3
Console(config)#logging sendmail source-email
[e-mail]
Console(config)#logging sendmail destination-email
[e-mail]
Console(config)#logging sendmail
Console#
Console#reload 4-22
System will be restarted, continue <y/n>? y